cultural and artisticHeritage and Tourismcultural and artisticHeritage and Tourism

The rules of the field and privacy of 4 historical works of Kermanshah were approved



According to Aria Heritage Report, Dariush Farmani from the Public Relations Department of the General Directorate of Cultural Heritage, Tourism and Handicrafts of Kermanshah announced that in the meeting of the Council of Protection of the Ministry of Cultural Heritage, with the efforts of the Deputy of Cultural Heritage of the province, the regulations of the area and protection of three hills and a historical site of the province were approved.

Director General of Cultural Heritage, Tourism and Handicrafts of Kermanshah added: These works are among the valuable areas of the province that have been explored in the last few years and valuable data and information have been discovered from them.

He continued: Qabaq Tepe (Qavakh Tepe) of Kuzran, as one of the valuable hills of the province, from which very valuable artifacts were obtained in the last two years, which as an Assyrian center had a lot of feedback in archeology circles, in this meeting Its area and privacy were approved.

Farmani said: Also, the regulations of the historical hills of Sarab Kermanshah, Sanghar God Hill were also approved, which are of special importance for protection according to the results of recent excavations.

He added: Finally, the regulations of the area and privacy of the historical area of ​​Yuan, which is of special importance in terms of the discovery of Neanderthal era artifacts, were also approved.

Director General of Cultural Heritage, Tourism and Handicrafts of Kermanshah said: With the approval of the rules of the area and privacy of these historical monuments, their protection will be pursued more seriously within the framework of the standards of cultural heritage.

More than 4,000 historical monuments have been identified in Kermanshah province, of which more than 2,200 have been registered in the national register.

end of message/

Leave a Reply

Back to top button